SC 200+ / SC 400+ | E+ Container Type

High-strength and high-stiffness prestressing container made by the stripwinding principle. The inner core of the stripwinding tool is of tungsten carbide, and the steel strip material can withstand up to 200° C for the SC 200+ and up to 400° C for the SC 400+. The outer steel ring is assembled to the stripwound section by heat shrinkage.

The SC 200+ and SC 400+ containers have about double strength and double stiffness compared to a standard steel compression ring and offer a unique capability to optimize the radial prestressing while reducing the physical deflection (i.e. strain) of the forming die under maximum process load. Furthermore, the SC 200+ and SC 400+ would stay in a fully elastic state during the press cycle. This unique product feature offers three important merits: Higher service life of the forming die, improved measure for controlling the part tolerance, and a prestressing tool that can be reused numerous times at full capacity. Specific calculations are required in each case.

The SC 200+ container is mostly applied for cold forging and comparable cold work applications involving high or even extreme tool loads.

The SC 400+ container is mostly applied for cold-heated and warm forming applications involving high or even extreme tool loads.

Both the SC 200+ and SC 400+ can be used on all types of press machines. Minimum diameter of both containers can be approx. ø60 mm.

PDF icon Catalog - SC 200+ / SC 400+

Contact icon Send inquiry


Prestressing containers SC200+ and SC400+ for radial prestressing of dies
See more
STRECON Prestressing Tool System H-Type for horizontal presses

PTS - Prestressing Tool System / H-Type

STRECON Prestressing Tool System V-Type for vertical press machines

PTS - Prestressing Tool System / V-Type

STRECON stripwound containers SC 200 and SC 400 for radial prestressing

SC 200 / SC 400

STRECON SC AXI-FIT stripwound container system for radial and axial prestressing of forming dies for cold and warm forming applications


STRECON compression ring of two or three rings designed for radial prestressing of forming dies

Double Ring

Prestressing tool solution designed specifically for a customer's press equipment

Customized Tool Solutions

Copyright 2024 STRECON A/S, All rights reserved